BMW R1150RT - MAINTENANCE INTEGRAL ABS Manual de servicio Pagina 87

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 96
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 86
34.24
e Attention:
The brake fluid must always be visible in the contain-
er, because the piston in the base of the wheel-cir-
cuit reservoir must always be covered by the fluid.
The procedure must be repeated if the fluid drops
below the min level.
Gently pull the handbrake lever until the pump
just starts up.
Open the bleed screw, while topping up the
container with new brake fluid if necessary.
Pump out the brake fluid with virtually no pres-
sure to begin with, then vary the brake pressure.
L Note:
The higher the brake pressure the faster the fluid is
pumped through the system, which means that the
level in the wheel-circuit reservoir drops all the more
rapidly.
Pump off brake fluid until it emerges clear and
free from air bubbles.
Close the bleed screw.
Release the brake.
Disconnect the brake bleeding device from the
bleed screw.
Connect the brake bleeding device to the bleed
screw of the right brake caliper, but do not
switch on the device.
L Note:
If necessary, use a cable tie to secure the bleed
hose to the bleed screw.
The procedure for changing the brake fluid in the
right brake caliper is the same as that for the
left caliper.
When the brake fluid is clear and free of bubbles,
continue pumping until the fluid in the container
just disappears from view.
Close the bleed screw.
Release the brake and switch off the ignition.
Disconnect the brake bleeding device from the
bleed screw.
Disconnect the container from the wheel-circuit
reservoir.
e Attention:
After changing and/or bleeding the brakes, always
top up the fluid in the wheel-circuit reservoir to the
correct level in accordance with the instructions.
MAX
MI N
R28340090
Vista de pagina 86
1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 95 96

Comentarios a estos manuales

Sin comentarios