BMW ONBOARD COMPUTER Manual de servicio descargar pdf (Pagina 104)

on-board socket is switched off

when this happens.

Comply with the operating in-

structions of the charger.

If you are unable to charge

the battery through the on-

board socket, you may be using

a charger that is not compatible

with your motorcycle's electron-

ics. If this happens, disconnect

the battery from the on-board

systems and connect the charger

directly to the battery.

Charging battery when

disconnected

Charge the battery using a

suitable charger.

Comply with the operating in-

structions of the charger.

After charging, remove the pole

terminal of the charger from

the battery posts.

The battery has to be re-

charged at regular intervals

in the course of a lengthy period

of disuse. See the instructions

for caring for your battery. Al-

ways fully recharge the battery

before restoring it to use

Removing battery

Make sure the ground is level

and firm and place the motor-

cycle on its stand.

with anti-theft alarm

If applicable, switch off the anti-

theft alarm.

Switch off the ignition.

Removing centre trim panel

( 98).

Disconnection in the wrong

sequence increases the risk

of short-circuits.

Always proceed in the correct

sequence.

Disconnect negative lead 1

first.

Then disconnect positive

lead 2.

Remove screw 3 and remove

the battery holder.

Lift the battery up and out;

work it slightly back and forth

if it is difficult to remove.

102

Maintenance

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 147 148

Comentarios a estos manuales

Sin comentarios

BMW ONBOARD COMPUTER Manual de servicio Pagina 104

Comentarios a estos manuales

Relacionado con productos y manuales para Barebones Pc / Estación De Trabajo BMW ONBOARD COMPUTER