BMW R1150RT - MAINTENANCE INTEGRAL ABS Manual de servicio Pagina 76

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 96
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 75
34.13
Checking and adjusting setting of rear
brake light switch
Checking setting of brake light switch, rear
Switch on the ignition.
L Note:
After switching on the ignition, always wait for the
BMW Integral ABS to complete its self-diagnosis.
Do not operate the brake lever until self-diagnosis
has completed.
Depress the footbrake lever (brake light comes
on and pump starts up).
Insert feeler gauge at right angles to direction of
travel between the brake-light switch lever (3)
and the stop on the footrest plate (arrow).
Slowly release the footbrake lever and check the
point at which the switch trips.
Brake light switch must switch off
Feeler gauge thickness: ........ 0.90 mm (0.0354 in)
Brake light switch must remain on
Feeler gauge thickness: ........ 1.60 mm (0.0629 in)
Switch off the ignition.
Adjusting brake light switch, rear
Depress the footbrake lever and secure it in this
position.
Slacken screw (4).
Turn the brake light switch until the switch trips
at distance (B).
Hold the brake light switch and tighten the
screw.
Recheck the setting.
Distance B: ......... 1 + 0.5 mm (0.0393 + 0.1968 in)
(clearance at switching point between brake-light
switch lever and footrest plate).
Removing and installing piston in
brake-lever fitting
a ....................................................See Group 32
R22340020
B
3
R22340030
4
R22340020
B
Vista de pagina 75
1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 95 96

Comentarios a estos manuales

Sin comentarios